|
||||||||||
|
||||||||||
7 Aug 2013, 20:41 (Ref:3287023) | #1 | ||
Racer
Join Date: Jun 2012
Posts: 107
|
Stupid Questions
Hey guys-stupid question-how do you make a wall and a bridge in sketchup?
|
||
|
7 Aug 2013, 20:45 (Ref:3287025) | #2 | ||
Veteran
Join Date: Jun 2012
Posts: 2,336
|
I've been trying to figure out that one as well...
|
||
|
7 Aug 2013, 21:01 (Ref:3287029) | #3 | ||
Rookie
Join Date: Jun 2011
Posts: 83
|
Quote:
1. draw the wall 2. use the offset tool to get the curves right, I usually put the other line about half a meter away 3. connect the curves and close the ends 4. use the lifting tool For (very simple) bridges... 1. Draw 2 boxes 2. Draw lines straight up in the corners closest to each other between the boxes 3. Connect the parts that go up with each other 4. Make the slopes by drawing lines from the top to the bottom This is the simplest way. I think. |
||
|
7 Aug 2013, 22:50 (Ref:3287054) | #4 | |||
Racer
Join Date: Mar 2011
Posts: 241
|
Quote:
|
|||
|
7 Aug 2013, 22:57 (Ref:3287056) | #5 | ||
Race Official
Veteran
Join Date: Jul 2003
Posts: 5,715
|
That pretty much covers it, remember though that there is the Sketchup tutorial thread available. You can place questions there, and users can post a "how to" complete with screen shots where required.
|
||
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
They say theres no Stupid questions? | CombeMarshal | Marshals Forum | 24 | 4 Oct 2005 14:39 |